The words contained in this file might help you see if this file matches what you are looking for:
...Tip the best way to connect clamp is tighten wheel until contact made with injector pipe then turn of a revolution more used as ground connection for piezo must be clean insure good electrical and if necessary can use an abrasive paper on make certain does not touch any other part engine except otherwise sensing element may send false signals due s vibration led diesel converter box flashing check cable connections well it has timing light cannot triggered while et refer instructions petrol shown p in this manual operating take measurements v read values display when captures rpm readout will emit flash signal value however prior do test tach advance dwell volts should warmed up temperature tester table contents safety precautions prevent accidents that could possibly result serious injury or damage vehicles equipment carefully observe all rules procedures working introduction wear loose clothing jewelry get caught fan pulleys belts etc conduct current cause severe burns comes between ...