The words contained in this file might help you see if this file matches what you are looking for:
...Technical note tn esd simulator calibration for iec is by wei huang jerry tichenor and david pommerenke iso objective the of this report to present parameters required simulators verify their performance compare results requirements or standard equipment tip voltage verification both specify that hv source an must be verified with a high meter electrostatic voltmeter up kv tolerance table when using contact g ohm input impedance will need continuously charge maintain level otherwise discharge reading decrease gradually es from esdemc satisfies measures less than because sharp small capacitive coupling between non weak therefore x reference plane oscilloscope ghz analog band require waveforms tested times at each all should within calculated average t i r p specification then mode current waveform page technology llc enterprise dr suite rolla mo usa www com tel fax email info target adapter line calibrate frequency response test setup mounted in center m larger vertical can one wall far...