2001-01-0308 FMEA-based Design for Remanufacture using Automotive- Remanufacturer Data A. Lam, M. Sherwood L. H. Shu (Corresponding Author) Department of Mechanical and Industrial Engineering University of Toronto Copyright © 2000 Society of Automotive Engineers, Inc. ABSTRACT of Asia, that assigns responsibility for products at the end-of-life to manufacturers, more products have been This paper describes the development of a Failure designed for ease of scrap-material recycling. Scrap- Modes and Effects Analysis (FMEA) modified to support material recycling involves separating a product into design for remanufacture. The results of the waste- different materials and reprocessing the materials for use stream analysis ...

 

e-ISSN: 2582-5208 International Research Journal of Modernization in Engineering Technology and Science ( Peer-Reviewed, Open Access, Fully Refereed International Journal ) Volume:04/Issue:09/September-2022 Impact Factor- 6.752 www.irjmets.com CONCEPTUAL DESIGN PHASE OF FMEA PROCESS FOR AUTOMOTIVE ELECTRONIC CONTROL UNITS *1 Venkata Satya Rahul Kosuru*1, Ashwin Kavasseri Venkitaraman*2 MS (Electrical And Computers Engineering), Independent Researcher, Sunnyvale, CA, USA. *2 MS (Electrical Engineering), Independent Researcher, Fremont, CA, USA. DOI : https://www.doi.org/10.56726/IRJMETS30103 ABSTRACT The main research of this paper describes about deriving safety on Electronic Controller Units or well-known called by (ECU’s) in Automotive by conducting a &ldquo ...